Shown above P3356 system w/72" cross bars w/part # A67 Kayak holder

Max Load capacity of 600 lbs 2 bars (evenly distributed)

Vertical upright bars stay straight 90 degrees right angle

No Drilling ! Gen2 Fits into existing bed rail slots.

Front and rear vertical bars are made different heights to accommodate sloping bed rail

Fits all Honda Ridgeline models from 2005-2010

Same height as Original factory roof racks

Average installation time 30 minutes (NO drilling)

65" wide Reinforced extruded aluminum tubing (72" wide system available during check-out)

3x Tools required to install entire system, Phillips head screwdriver and 5/8" socket wrench (allen key included)

Cross bars and uprights are designed to be aerodynamic for little to no wind resistance resulting in less wind noise

Bed rail adaptor plate is made of 14 gauge steel galvanized and powder coated.

Rubber end caps prevent wind noise and provides extra protection

Entire unit weighs in at approx. 52lbs including hardware

2x 43" aluminum tracks allows the mounting base to adjust slightly in length and tilt

All aluminum tubing are reinforced and welded with precision

Mounting Uprights can detach off base within minutes

All stainless steel hardware

Powder coated high-gloss finish  (choice of black or silver)

Upright mount has additional channel for additional accessory upgrade

5 year limited warranty

Note: The Gen2 system will not work with factory tonneau and bakflip covers. An attachment is being developed right to allow the rear doors to open by Fall 2010'.

Available in 4 combo systems at discounted price

(additional accessories available at bottom of the page)